高级搜索

废旧晶体硅光伏组件的回收利用

,  ,  , 

downloadPDF

上一篇

下一篇

徐创, 袁晓, 柳翠, 沈春银. 废旧晶体硅光伏组件的回收利用[J]. 环境工程学报, 2019, 13(6): 1417-1424. doi: 10.12030/j.cjee.201901113
引用本文: 徐创, 袁晓, 柳翠, 沈春银. 废旧晶体硅光伏组件的回收利用[J]. 环境工程学报, 2019, 13(6): 1417-1424. doi: 10.12030/j.cjee.201901113
shu
XU Chuang, YUAN Xiao, LIU Cui, SHEN Chunyin. Recycling of waste crystalline silicon photovoltaic modules[J]. Chinese Journal of Environmental Engineering, 2019, 13(6): 1417-1424. doi: 10.12030/j.cjee.201901113
Citation: XU Chuang, YUAN Xiao, LIU Cui, SHEN Chunyin. Recycling of waste crystalline silicon photovoltaic modules[J]. Chinese Journal of Environmental Engineering, 2019, 13(6): 1417-1424. doi: 10.12030/j.cjee.201901113
shu

废旧晶体硅光伏组件的回收利用

  • 1.

    华东理工大学材料科学与工程学院，上海 200237

  • 2.

    华东理工大学化学工程学院，化学工程联合国家重点实验室，上海 200237

  • 基金项目:

    上海市科技创新计划17DZ1201102上海市科技创新计划(17DZ1201102)

Recycling of waste crystalline silicon photovoltaic modules

  • 1.

    School of Materials Science and Engineering, East China University of Science and Technology, Shanghai 200237, China

  • 2.

    State Key Laboratory of Chemical Engineering, School of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China

  • Fund Project:

  • 摘要: 为应对光伏产业的快速发展而产生的废旧光伏组件高效低污染回收利用的问题，对不同气氛下光伏封装材料及背板材料的热失重行为及其产物进行了实验分析；并利用高温箱式炉对晶体硅组件进行热处理回收研究。考察了热处理温度、升温速率以及有无背板对硅晶片回收的影响。结果表明，封装材料和背板材料在空气气氛下均存在2个失重阶段，且最终失重温度为500 ℃左右。通过高温热处理，能够完全去除背板和封装材料，且能回收完整的表面玻璃。预先去除背板的光伏电池在热处理后的硅晶片完整性明显比未去除背板的光伏组件好。以20 ℃·min-1的升温速率加热至480 ℃，得到了高完整性的回收硅晶片。
    Abstract: With the rapid development of the photovoltaic industry, the production and installation of global PV modules have risen sharply. In order to cope with the recycling of waste PV module with high efficiency and low pollution, the thermogravimetry analysis under different atmospheres was used to analyze the weight loss behaviors and products of the encapsulating and backing plate materials. At the same time, the silicon PV modules were recycled by heat treatment using a box furnace. The effects of heating temperature, heating rate, and the backing plate removal or not on the silicon wafer were discussed. The results show that both the package and the backing plate material had two weight loss stages under air atmosphere, and the final weight loss temperature was about 500 ℃. Through the high temperature thermal treatment, the backing plate and encapsulating material could be completely removed, and the complete surface glass could be recovered. The silicon wafer from the thermal treated photovoltaic cells without backing plate generally presented a better integrity than ordinary photovoltaic modules with backing plate. A high integrity silicon wafer could be produced when heating to 480 ℃ with a rising rate of 20 ℃·min-1.
  • 加载中
  • [1] HUANG B, ZHAO J, CHAI J, et al. Environmental influence assessment of China’s multi-crystalline silicon (multi-Si) photovoltaic modules considering recycling process[J]. Solar Energy, 2017, 143: 132-141.
    [2] SHIN J, PARK J, PARK N. A method to recycle silicon wafer from end-of-life photovoltaic module and solar panels by using recycled silicon wafers[J]. Solar Energy Materials and Solar Cells, 2017, 162: 1-6.
    [3] DIAS P, SCHMIDT L, GOMES L B, et al. Recycling waste crystalline silicon photovoltaic modules by electrostatic separation[J]. Journal of Sustainable Metallurgy, 2018, 4(2): 176-186.
    [4] TAO J, YU S. Review on feasible recycling pathways and technologies of solar photovoltaic modules[J]. Solar Energy Materials and Solar Cells, 2015,141: 108-124.
    [5] 罗付香, 彭晓春, 吴彦瑜, 等. 废旧晶硅太阳能电池的回收拆解及进展研究[J]. 环境科学与管理, 2014, 39(12): 160-163.
    [6] HUANG W H, SHIN W J, WANG L, et al. Strategy and technology to recycle wafer-silicon solar modules[J]. Solar Energy, 2017, 144: 22-31.
    [7] ILIAS A V, MELETIOS R G, YIANNIS K A, et al. Integration & assessment of recycling into c-Si photovoltaic module’s life cycle[J]. International Journal of Sustainable Engineering, 2018, 3: 1-10.
    [8] KIM Y, LEE J. Dissolution of ethylene vinyl acetate in crystalline silicon PV modules using ultrasonic irradiation and organic solvent[J]. Solar Energy Materials and Solar Cells, 2012, 98: 317-322.
    [9] DIAS P, JAVIMCZIK S, BENEVIT M, et al. Recycling WEEE: Polymer characterization and pyrolysis study for waste of crystalline silicon photovoltaic modules[J]. Waste Management, 2017, 60: 716-722.
    [10] PARK J, KIM W, CHO N, et al. An eco-friendly method for reclaimed silicon wafers from a photovoltaic module: From separation to cell fabrication[J]. Green Chemistry, 2016, 18(6): 1706-1714.
    [11] 田建军, 姜恒, 苏婷婷, 等. 基于TGA-FTIR联用技术的EVA热解研究[J]. 分析测试学报, 2003, 22(5): 100-102.
    [12] MARCILLA A, GOMEZ A, MENARGUES S. TG/FTIR study of the thermal pyrolysis of EVA copolymers[J]. Journal of Analytical and Applied Pyrolysis, 2005, 74(1/2): 224-230.
    [13] 陈玉君, 侯巩. 聚对苯二甲酸丙二酯的热降解性能研究[J]. 聚酯工业, 2005, 18(2): 27-30.
    [14] 董莉, 刘景洋, 张建强, 等. 废晶体硅光伏组件资源化处理技术研究现状[J]. 现代化工, 2014, 34(2): 20-23.
    [15] TAMMARO M, RIMAYRO J, FIANDRA V, et al. Thermal treatment of waste photovoltaic module for recovery and recycling: Experimental assessment of the presence of metals in the gas emissions and in the ashes[J]. Renewable Energy, 2015, 81: 103-112.
    [16] PARK J, PARK N. Wet etching processes for recycling crystalline silicon solar cells from end-of-life photovoltaic modules[J]. RSC Advances, 2014, 4(66): 34823-34829.
  • 加载中
WeChat 点击查看大图
计量
  • 文章访问数:  6810
  • HTML全文浏览数:  6751
  • PDF下载数:  218
  • 施引文献:  0
出版历程
  • 刊出日期:  2019-06-18

废旧晶体硅光伏组件的回收利用

  • 1. 华东理工大学材料科学与工程学院，上海 200237
  • 2. 华东理工大学化学工程学院，化学工程联合国家重点实验室，上海 200237
基金项目:

上海市科技创新计划17DZ1201102上海市科技创新计划(17DZ1201102)

摘要: 为应对光伏产业的快速发展而产生的废旧光伏组件高效低污染回收利用的问题，对不同气氛下光伏封装材料及背板材料的热失重行为及其产物进行了实验分析；并利用高温箱式炉对晶体硅组件进行热处理回收研究。考察了热处理温度、升温速率以及有无背板对硅晶片回收的影响。结果表明，封装材料和背板材料在空气气氛下均存在2个失重阶段，且最终失重温度为500 ℃左右。通过高温热处理，能够完全去除背板和封装材料，且能回收完整的表面玻璃。预先去除背板的光伏电池在热处理后的硅晶片完整性明显比未去除背板的光伏组件好。以20 ℃·min-1的升温速率加热至480 ℃，得到了高完整性的回收硅晶片。

English Abstract

    全文HTML

参考文献 (16)

目录

/

返回文章
返回

Copyright © 2019 中国科学院生态环境研究中心