高级搜索

DOC系统催化性能的仿真和分析

,  ,  ,  , 

downloadPDF

上一篇

下一篇

谭理刚, 郭雅各, 杨树宝, 冯鹏飞, 李子文. DOC系统催化性能的仿真和分析[J]. 环境工程学报, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
引用本文: 谭理刚, 郭雅各, 杨树宝, 冯鹏飞, 李子文. DOC系统催化性能的仿真和分析[J]. 环境工程学报, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
shu
TAN Ligang, GUO Yage, YANG Shubao, FENG Pengfei, LI Ziwen. Numerical simulation and analysis of catalytic performance of DOC system[J]. Chinese Journal of Environmental Engineering, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
Citation: TAN Ligang, GUO Yage, YANG Shubao, FENG Pengfei, LI Ziwen. Numerical simulation and analysis of catalytic performance of DOC system[J]. Chinese Journal of Environmental Engineering, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
shu

DOC系统催化性能的仿真和分析

  • 1.

    湖南大学汽车车身先进设计制造国家重点实验室，长沙 410082

  • 2.

    广西玉柴机器股份有限公司，玉林 537000

  • 基金项目:

    国家科技支撑计划项目（2014BAG09B-01）

Numerical simulation and analysis of catalytic performance of DOC system

  • 1.

    State Key Laboratory of Advanced Design and Manufacturing for Vehicle Body, Hunan University, Changsha 410082, China

  • 2.

    Guangxi Yuchai Machinery Co.Ltd., Yulin 537000, China

  • Fund Project:

  • 摘要: 以 Langmuire Hinshelwood机理为理论依据，基于MATLAB/Simulink 建立DOC系统的数值计算模型，研究不同参数(如空速、氧气浓度、NO2/NOx比例)对氮氧化物（NOx）、一氧化碳（CO）、碳氢化合物（HC）转化效率的影响, 并对部分工况进行了实验研究，从而验证数值模型的准确性。结果表明，空速的降低可以增大DOC对CO、HC、NO的氧化性能，这是由于排气在催化器内的反应时间增长。当排气温度为225～300 ℃时，减小空速对增大HC的氧化效率效果明显，当排气温度在175～450 ℃范围内，减小空速对增大NO的氧化效率影响明显；当O2浓度低于1%，排气温度在175～250 ℃时，CO转化效率增大，在250 ℃之后均接近100%。当O2浓度为10%时，温度的变化对CO的转化效率影响很小。当O2浓度大于1%时，温度的变化对NO的氧化效率影响较大；当排气温度在300～550 ℃时，NO2/NOx比例的变化对NO的转化效率影响较大。降低排气中NO2/NOx比例，能够在排气温度高于300 ℃时，明显提高NO的转化效率。
    Abstract: Based on Langmuire Hinshelwood mechanism, a numerical simulation model of DOC was established under the environmental of the MATLAB/Simulink. After introducing mathematical models for the DOC reaction, the effects of various parameters such as gas hourly space velocity, the O2 concentrations and the ratio of NO2/NOx on the CO，HC，NO conversion efficiencies are thoroughly studied and validated by comparing with the experimental data. The results show that lowering the space velocity can improve the DOC performance due to the residence time of the exhaust gas increases. The HC conversion efficiency depends strongly on the space velocity in the range of 225 ℃ and 300 ℃. The NO conversion efficiency depends strongly on the space velocity in the range of 175 ℃ and 450 ℃. The CO conversion efficiency increase with temperature and reaches nearly 100% in the range 250 ℃ and 550 ℃ when the O2 concentration lower than 10%. The O2 concentration greater than 10% have no significant effects on the CO conversion efficiency. The NO conversion efficiency depends strongly on the temperature when the O2 concentration greater than 1%. The NO conversion efficiency depends strongly on the NO2/NOx ratio in the range of 300 ℃ and 550 ℃. Lowing the NO2/NOx ratio can improve the NO conversion efficiency when the temperature greater than 300 ℃.
  • 加载中
  • [1] KOTA S H, ZHANG H L, CHEN G, et al.Evaluation of on-road vehicle CO and NOx national emission inventories using an urban-scale source-oriented air quality model[J].Atmospheric Environment,2014,85:99-108 10.1016/j.atmosenv.2013.11.020
    [2] SKALSKA K, MILLER J S, LEDAKOWICZ S.Trends in NOx abatement:A review[J].Science of the Total Environment,2010,408(19):3976-3989 10.1016/j.scitotenv.2010.06.001
    [3] VERSCHAEREN R, SCHAEPDRYVER W, SERRUYS T, et al.Experimental study of NOx reduction on a medium speed heavy duty diesel engine by the application of EGR (exhaust gas recirculation) and Miller timing[J].Energy,2014,76:614-621 10.1016/j.energy.2014.08.059
    [4] BHASKAR K,NAGARAJAN G,SAMPATH S.Optimization of FOME (fish oil methylesters) blend and EGR (exhaust gas recirculation) for simultaneous control of NOx and particulate matter emissions in diesel engines[J].Energy,2013,62:224-234 10.1016/j.energy.2013.09.056
    [5] JAFARMADAR S.Multidimensional modeling of the effect of EGR (exhaust gas recirculation) mass fraction on energy terms in an indirect injection diesel engine[J].Energy,2014,66:305-313 10.1016/j.energy.2014.01.040
    [6] KITTELSON D B, WATTS W F, JOHNSON J P, et al.On-road evaluation of two diesel exhaust aftertreatment devices[J].Journal of Aerosol Science,2006, 37(9):1140-1151 10.1016/j.jaerosci.2005.11.003
    [7] GUO M Y, FU Z C, MA D G, et al.A short review of treatment methods of marine dieselengine exhaust gases[J].Procedia Engineering,2015,121:938-943 10.1016/j.proeng.2015.09.059
    [8] CIMINO S, LISI L, TORTORELLI M.Low temperature SCR on supported MnOx catalysts for marine exhaust gas cleaning:Effect of KCl poisoning[J].Chemical Engineering Journal,2016,283:223-230 10.1016/j.cej.2015.07.033
    [9] CAUDA E, FINO D, SARACCO G, et al.Secondary nanoparticle emissions during diesel particulate trap regeneration[J].Topics in Catalysis,2007, 42-43(1/2/3/4):253-257 10.1007/s11244-007-0186-y
    [10] HARADA K, YAMADA H, OKAMOTO K, et al.Development of high performance catalyzed DPF with new soot burning mechanism[J].Catalysis Surveys from Asia, 2010, 14(3/4):176-184 10.1007/s10563-010-9099-z
    [11] TAN P Q.Effects of diesel particulate filter structural parameters on filtration performance of different size particles[J].Chinese Journal of Mechanical Engineering,2008,44(2):175-181
    [12] KNECHT W.Diesel engine development in view of reduced emission standaras[J].Energy,2008,33(2):264-271 10.1016/j.energy.2007.10.003
    [13] TWIGG M V.Progress and future challenges in controlling automotive exhaust gas emissions[J].Applied Catalysis B: Environmental,2007,70(1/2/3/4):2-15 10.1016/j.apcatb.2006.02.029
  • 加载中
WeChat 点击查看大图
计量
  • 文章访问数:  3194
  • HTML全文浏览数:  2939
  • PDF下载数:  243
  • 施引文献:  0
出版历程
  • 刊出日期:  2018-07-26
谭理刚, 郭雅各, 杨树宝, 冯鹏飞, 李子文. DOC系统催化性能的仿真和分析[J]. 环境工程学报, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
引用本文: 谭理刚, 郭雅各, 杨树宝, 冯鹏飞, 李子文. DOC系统催化性能的仿真和分析[J]. 环境工程学报, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
shu
TAN Ligang, GUO Yage, YANG Shubao, FENG Pengfei, LI Ziwen. Numerical simulation and analysis of catalytic performance of DOC system[J]. Chinese Journal of Environmental Engineering, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
Citation: TAN Ligang, GUO Yage, YANG Shubao, FENG Pengfei, LI Ziwen. Numerical simulation and analysis of catalytic performance of DOC system[J]. Chinese Journal of Environmental Engineering, 2018, 12(7): 2004-2009. doi: 10.12030/j.cjee.201712105
shu

DOC系统催化性能的仿真和分析

  • 1. 湖南大学汽车车身先进设计制造国家重点实验室，长沙 410082
  • 2. 广西玉柴机器股份有限公司，玉林 537000
基金项目:

国家科技支撑计划项目（2014BAG09B-01）

摘要: 以 Langmuire Hinshelwood机理为理论依据，基于MATLAB/Simulink 建立DOC系统的数值计算模型，研究不同参数(如空速、氧气浓度、NO2/NOx比例)对氮氧化物（NOx）、一氧化碳（CO）、碳氢化合物（HC）转化效率的影响, 并对部分工况进行了实验研究，从而验证数值模型的准确性。结果表明，空速的降低可以增大DOC对CO、HC、NO的氧化性能，这是由于排气在催化器内的反应时间增长。当排气温度为225～300 ℃时，减小空速对增大HC的氧化效率效果明显，当排气温度在175～450 ℃范围内，减小空速对增大NO的氧化效率影响明显；当O2浓度低于1%，排气温度在175～250 ℃时，CO转化效率增大，在250 ℃之后均接近100%。当O2浓度为10%时，温度的变化对CO的转化效率影响很小。当O2浓度大于1%时，温度的变化对NO的氧化效率影响较大；当排气温度在300～550 ℃时，NO2/NOx比例的变化对NO的转化效率影响较大。降低排气中NO2/NOx比例，能够在排气温度高于300 ℃时，明显提高NO的转化效率。

English Abstract

参考文献 (13)

返回顶部

目录

/

返回文章
返回

Copyright © 2019 中国科学院生态环境研究中心