微波预处理对制革污泥絮凝脱水性能的影响

罗海健, 付长亮, 宁寻安, 刘敬勇, 梁秀娟. 微波预处理对制革污泥絮凝脱水性能的影响[J]. 环境工程学报, 2013, 7(5): 1933-1938.
引用本文: 罗海健, 付长亮, 宁寻安, 刘敬勇, 梁秀娟. 微波预处理对制革污泥絮凝脱水性能的影响[J]. 环境工程学报, 2013, 7(5): 1933-1938.
Luo Haijian, Fu Changliang, Ning Xunan, Liu Jingyong, Liang Xiujuan. Influence of microwave pretreatment on tannery sludge flocculating and dewatering performances[J]. Chinese Journal of Environmental Engineering, 2013, 7(5): 1933-1938.
Citation: Luo Haijian, Fu Changliang, Ning Xunan, Liu Jingyong, Liang Xiujuan. Influence of microwave pretreatment on tannery sludge flocculating and dewatering performances[J]. Chinese Journal of Environmental Engineering, 2013, 7(5): 1933-1938.

微波预处理对制革污泥絮凝脱水性能的影响

  • 基金项目:

    广东省部产学研结合项目(2011B090400161)

    广东省高校优秀青年创新人才培养项目(LYM11059)

  • 中图分类号: X705

Influence of microwave pretreatment on tannery sludge flocculating and dewatering performances

  • Fund Project:
  • 摘要: 分别采用微波、絮凝剂和微波联合絮凝剂对制革污泥进行脱水预处理,考察不同处理条件下制革污泥沉降速率(SV30)、毛细吸水时间(CST)和污泥比阻(SRF)的变化,并通过粘度、水分分布和微观结构的变化探讨相关的脱水机理。结果表明,在微波输出功率为648 W、辐射时间为60 s的预处理条件下,阳离子聚丙烯酰胺(CPAM)投加剂量为8 mg/L时,污泥脱水性能达到最佳。与单独添加絮凝剂的污泥脱水相比,该条件下的SV30、CST和SRF分别降低了25.0%、48.9%和34.7%。污泥絮凝脱水前进行微波预处理能够进一步提高污泥的脱水性能,微波辐射联合CPAM进行污泥脱水时,CPAM则起主要脱水作用。微波辐射通过破坏污泥絮体结构,改变污泥中的水分分布,降低污泥的粘度,从而提高污泥的脱水性能。
  • [1] Yuan H.P.,Cheng X.B.,Chen X.P.,et al.New sludge pretreatment method to improve dewaterability of waste activated sludge.Bioresource Technology,2011,102 (10):5659-5664
    [2] Chen Y.G., Chen Y.S.,Gu G.W.Influence of pretreating activated sludge with acid and surfactant prior to conventional conditioning on filtration dewatering.Chemical Engineering Journal,2004,99 (2):137-143
    [3] Chena B.H.,Lee S.J.,Lee D.J.Rheological characteristics of the cationic polyelectrolyte flocculated wastewater sludge.Water Research,2005,39 (18):4429-4435
    [4] Chitikela, Srinivasarao Dentel,Steven K.Dual-chemical conditioning and dewatering of anaerobically digested biosolids: Laboratory evaluations.Water Environment Research,1998,70 (5):1062-1069
    [5] A.Fakhru'l-Razi,Molla A.H.Enhancement of bioseparation and dewaterability of domestic wastewater sludge by fungal treated dewatered sludge.Hazardous Waste and Hazardous Materials,2007,147 (1-2):350-356
    [6] Agarwal S.,Abu-Orf M.,Novak J.T.Sequential polymer dosing for effective dewatering of ATAD sludges.Water Research,2005,39 (7):1301-1310
    [7] Vander Roest H.F.,Roeleveld P.,Stamperius P.Optimising sludge treatment in the Netherlands. Water,1999,21(8-9):23-25
    [8] Carrère H.,Dumas C.,Battimelli A.Pretreatment methods to improve sludge anaerobic degradability:A review.Journal of Hazardous Materials,2010,183 (2):1-15
    [9] Neelan Cherry Remya,Lin J.G.Current status of microwave application in wastewater treatment:A review.Chemical Engineering Journal,2011,166 (3):797-813
    [10] Yu Q.,Lei H.Y.,Yu G.W.Influence of microwave irradiation on sludge dewaterability.Chemical Engineering Journal,2009,155 (1-2):88-93
    [11] 田禹,方琳,黄君礼.微波辐射预处理对污泥结构及脱水性的影响.中国环境科学,2006,26 (4):459-463 Tian Yu,Fang Lin,Huan Junli.Influence of microwave pretreatment on activated sludge structure and dewaterability.China Environmental Science,2006,26 (4):459-463 (in Chinese)
    [12] Yu Q.,Lei H.Y.,Li Z.,et al.Physical and chemical properties of waste-activated sludge after microwave treatment.Water Research,2010,44 (9):2841-2849
    [13] 乔玮,王伟,黎攀.城市污水污泥微波热水解特性研究.环境科学,2008,29 (1):152-157 Qiao Wei,Wang Wei,Li Pan. Sewage sludge microwave thermal hydrolysis process.Environmental Science,2008,29 (1):152-157(in Chinese)
    [14] Kopp J., Dichtl N. Prediction of full-scale dewatering results of sewage sludges by the physical water distribution. Water Science and Technology, 2001,43 (11):135-143
    [15] Yu Q.,Lei H.Y.,Yu G. W.Influence of microwave irradiation on sludge dewaterability.Chemical Engineering Journal,2009,155 (1-2):88-93
    [16] Jill Ruhsing Pan,Chihpin Huang,Minyih Cherng,et al.Correlation between dewatering index and dewatering performance of three mechanical dewatering device.Advances in Environmental Research, 2003, 7 (3):599-602
    [17] 王鲁嘉.微波灭菌试验及分析.云南大学学报(自然科学版),1998,20 (1):34-36 Wang Lujia.The study of microwave sterilization. Journal of Yunnan University(Natural Science),1998,20 (1):34-36 (in Chinese)
    [18] Feng X.,Deng H.C.,Lei H.Y.,et al.Dewaterability of waste activated sludge with ultrasound conditioning.Bioresource Technology,2009,100 (3):1074-1081
    [19] Lasaridi K.E.,Stentiford E.I.,Szmidt R.A.K.Biological parameters for compost stability assessment and process evaluation.Acta Horticulturae,1988,469:119-128
    [20] Zhao Y.Q.Settling behaviour of polymer flocculated water-treatment sludge I:Analysis of settling curves.Separation and Purification Technology,2004,35 (1):71-80
    [21] Tang K.R.,Vesilind P.A.Moisture distribution in sludges.Water Science and Technology,1990, 22 (12):135-142
    [22] Kopp J.,Dichtl N.Influence of the free water content on the dewaterability of sewage sludges.Water Science and Technology,2001,44 (10):177-183
    [23] Chang M.C.,Lin H.L.,Huang C.L.Conditioning characteristics of kaolin sludge with different cationic polyelectrolytes. Colloids and Surfaces A: Physicochemical and Engineering Aspects,1998,139 (1):75-80
    [24] Lee C.H.,Liu J.C.Sludge dewaterability and floc structure in dual polymer conditioning.Advances in Environmental Research,2001,5 (2):129-136
  • 加载中
计量
  • 文章访问数:  1947
  • HTML全文浏览数:  1020
  • PDF下载数:  1029
  • 施引文献:  0
出版历程
  • 收稿日期:  2012-05-22
  • 刊出日期:  2013-05-22
罗海健, 付长亮, 宁寻安, 刘敬勇, 梁秀娟. 微波预处理对制革污泥絮凝脱水性能的影响[J]. 环境工程学报, 2013, 7(5): 1933-1938.
引用本文: 罗海健, 付长亮, 宁寻安, 刘敬勇, 梁秀娟. 微波预处理对制革污泥絮凝脱水性能的影响[J]. 环境工程学报, 2013, 7(5): 1933-1938.
Luo Haijian, Fu Changliang, Ning Xunan, Liu Jingyong, Liang Xiujuan. Influence of microwave pretreatment on tannery sludge flocculating and dewatering performances[J]. Chinese Journal of Environmental Engineering, 2013, 7(5): 1933-1938.
Citation: Luo Haijian, Fu Changliang, Ning Xunan, Liu Jingyong, Liang Xiujuan. Influence of microwave pretreatment on tannery sludge flocculating and dewatering performances[J]. Chinese Journal of Environmental Engineering, 2013, 7(5): 1933-1938.

微波预处理对制革污泥絮凝脱水性能的影响

  • 1. 广东工业大学环境科学与工程学院,广州 510006
  • 2. 河南化工职业学院,郑州 450042
基金项目:

广东省部产学研结合项目(2011B090400161)

广东省高校优秀青年创新人才培养项目(LYM11059)

摘要: 分别采用微波、絮凝剂和微波联合絮凝剂对制革污泥进行脱水预处理,考察不同处理条件下制革污泥沉降速率(SV30)、毛细吸水时间(CST)和污泥比阻(SRF)的变化,并通过粘度、水分分布和微观结构的变化探讨相关的脱水机理。结果表明,在微波输出功率为648 W、辐射时间为60 s的预处理条件下,阳离子聚丙烯酰胺(CPAM)投加剂量为8 mg/L时,污泥脱水性能达到最佳。与单独添加絮凝剂的污泥脱水相比,该条件下的SV30、CST和SRF分别降低了25.0%、48.9%和34.7%。污泥絮凝脱水前进行微波预处理能够进一步提高污泥的脱水性能,微波辐射联合CPAM进行污泥脱水时,CPAM则起主要脱水作用。微波辐射通过破坏污泥絮体结构,改变污泥中的水分分布,降低污泥的粘度,从而提高污泥的脱水性能。

English Abstract

参考文献 (24)

返回顶部

目录

/

返回文章
返回