高级搜索

涂料废渣水热减量及其产物特性

,  ,  , 

downloadPDF

上一篇

下一篇

游继光, 李响, 薛罡, 刘振鸿. 涂料废渣水热减量及其产物特性[J]. 环境工程学报, 2018, 12(5): 1557-1564. doi: 10.12030/j.cjee.201711025
引用本文: 游继光, 李响, 薛罡, 刘振鸿. 涂料废渣水热减量及其产物特性[J]. 环境工程学报, 2018, 12(5): 1557-1564. doi: 10.12030/j.cjee.201711025
shu
YOU Jiguang, LI Xiang, XUE Gang, LIU Zhenhong. Hydrothermal reduction of paint residue and properties of products[J]. Chinese Journal of Environmental Engineering, 2018, 12(5): 1557-1564. doi: 10.12030/j.cjee.201711025
Citation: YOU Jiguang, LI Xiang, XUE Gang, LIU Zhenhong. Hydrothermal reduction of paint residue and properties of products[J]. Chinese Journal of Environmental Engineering, 2018, 12(5): 1557-1564. doi: 10.12030/j.cjee.201711025
shu

涂料废渣水热减量及其产物特性

  • 1.

    东华大学环境科学与工程学院，上海201620

  • 2.

    江苏同盐环保科技有限公司，盐城224000

  • 基金项目:

    国家自然科学基金资助项目（51508084）

    江苏省自然科学基金资助项目（BK20150434）

Hydrothermal reduction of paint residue and properties of products

  • 1.

    College of Environmental Science and Engineering, Donghua University ,Shanghai 201620,China

  • 2.

    Jiangsu Tongyan Environmental Production Science and Technology Co.Ltd.,Yancheng 224000,China

  • Fund Project:

  • 摘要: 采用水热技术处理涂料废渣，考察了水热温度、反应时间、含水率和投碱量对涂料废渣减量及其产物特性的影响，并用SEM、元素分析对涂料废渣进行表征。实验结果表明：随着水热温度的升高及时间的延长，涂料废渣减量效果及水热液中COD、TN浓度不断增加，固体产物的热值也随之增加，而含水率对涂料废渣减量的影响不大；随着碱投加量的增加，涂料废渣减量效果和水热液中COD、TN浓度逐渐提高，固体产物的热值呈不规则变化。水热温度220 ℃、水热时间4 h、含水率77.5%、投碱量0.17 g（NaOH，投加量以每克干物质（DS）计）为涂料废渣减量的最佳反应条件。在最优条件下，总减量率和干重减量率分别为79.1%和52.1%，含水率为47.2%。水热固体产物热值较高，可以作燃料为其他工艺提供热能。
    Abstract: In this paper, the use of hydrothermal technology was introduced to treat with the paint residue. The influence of hydrothermal reaction temperature, time, water content and alkali dosage on the reduction efficiency of the paint residue was studied. The characteristics of the solid and liquid products after hydrothermal treatment were investigated through SEM and elemental analysis. The experimental results showed that with the increase of hydrothermal reaction temperature and time, the reduction efficiency of the paint residue and the concentration of COD and TN in the hydrolysate increased.In addition, the calorific value of the solid hydrothermal product also improved. However, the moisture content showed no significant impact on the reduction efficiency of the paint residue. With the increase of alkali dosage, the reduction efficiency and the concentration of COD and TN in the hydrolysate gradually increased with irregularly calorific value change of the solid product. In conclusion, the optimum reaction conditions for the paint residue reduction are as follows: hydrothermal treatment temperature of 220 ℃, hydrothermal time of 4 h, moisture content of 77.5 % and alkali dosage of 0.17 g (NaOH, per gram of DS). Under these conditions, the total weight reduction rate and dry weight reduction rate of paint residue are 79.1% and 52.1%, respectively, and the moisture content after treatment is 47.2%. The solid product by hydrothermal treatment exhibits high calorific value, which could be used as fuel to provide heat energy for other thermal processes.
  • 加载中
  • [1] VAAJASAARI K,KULOVAARA M,JOUTTI A,et al.Hazardous properties of paint residues from the furniture industry[J].Journal of Hazardous Materials,2004,106(2/3):71-79 10.1016/ j.jhazmat.2003.11.004
    [2] 袁园,汪晓雷.漆渣的循环再利用[J].再生资源与循环经济,2015,8(1):34-37
    [3] 曹桂清,杨志伟.油漆废渣回收再生利用[J].佛山科学技术学院学报（自然科学版）,2012,30(4):81-83
    [4] 胡芝娟,李海龙,赵亮,等.水泥窑协同处置废弃物技术研究及工程实例[J].中国水泥,2011(4):45-49
    [5] 钱晓荣,唐帆,董悦,杨双. 微生物降解油漆废渣技术综述[C]//中国环境科学学会.2014年中囯环境科学学术学术年会论文集.成都,2014:5792-5795
    [6] NEYENS E,BAEYENS J.A review of thermal sludge pre-treatment processes to improve dewaterability[J].Journal of Hazardous Materials,2003,98(1/2/3):51-67 10.1016/S0304-3894(02)00320-5
    [7] 万晓,张妍,张超,等.水热技术在污泥减量化和资源化中的应用[J].中国建设信息（水工业市场）,2010(8):55-57
    [8] LIU Y,TAY J H.Strategy for minimization of excess sludge production from the activated sludge process[J].BiotechnologyAdvances,2001,19(2):97-107 10.1016/S0734-9750(00)00066-5
    [9] PARSHETTI G K,LIU Z G,JAIN A,et al．Hydrothermal carbonization of sewage sludge for energy production with coal[J]．Fuel,2013,111:201-210 10.1016/j.fuel.2013.04.052
    [10] 赵丹,张琳,郭亮,等. 水热碳化与干法碳化对剩余污泥的处理比较[J]. 环境科学与技术,2015,38(10): 78-83
    [11] 王在钊,贾通通,王蛟秦,等. 水热预处理对污泥理化性质的影响[J].环境工程技术学报,2016, 6(5):440-446
    [12] BOUGRIER C,DELGENES J P,CARRERE H．Effects of thermal treatments on five different waste activated sludge samples solubilisation, physical properties and anaerobic digestion [J].Chemical Engineering Journal,2008,139(2):236-244 10.1016/j.cej.2007.07.099
    [13] 宜慧,韩芸,李玉友,等. 碱解+低温水热预处理改善剩余污泥中温厌氧消化性能工艺[J]. 环境工程学报,2014,8(9):3927-3932
    [14] 刘金凤,盛广宏,王诗生,等. 水热处理对污泥性质的影响[J]. 环境污染与防治,2013,35(11):71-76
    [15] 李洋洋,李欢,金宜英,等. 碱热联合处理用于污泥强化脱水[J]. 高校化学工程学报,2010,24(4):714-718
    [16] 甘雁飞,周宁娟,张若晨,等. 废水处理厂剩余污泥水热减量及改善脱水性能的研究[J].环境工程,2017，35(4):91-96 10.13205/j.hjgc.201704019
    [17] 国家环境保护总局. 水和废水监测分析方法[M].4版. 北京: 中国环境科学出版社, 2002: 254-257
    [18] SALIHOGLU G,SALIHOGLU N K.A review on paint sludge from automotive industries: Generation, characteristics and management[J].Journal of Environmental Management,2016,169:223-235 10.1016/j.jenvman.2015.12.039
    [19] 闫秀懿,乔玮,李飘,等. 含油污泥的水热法减量处理[J].化工环保,2014,34(4):340-343
    [20] 黄维,范同祥. 水热碳化法的研究进展[J]. 材料导报,2014,28(S1):131-135
    [21] 钱原吉,吴占松. 油漆废渣的热解特性与热解工艺[J]. 清华大学学报(自然科学版),2008,48(2):236-239
    [22] 姜雨生,陶能烨,李继荣. 油漆废渣机械脱水研究[C]//中国环境科学学会.2014年中囯环境科学学会学术年会论文集.成都,2014:5846-5851
    [23] 荀锐,王伟,乔玮,尹可清. 城市污泥处理现状与强化脱水的水热减量化技术[J]. 环境卫生工程,2008,16(2):28-32
    [24] 盛广宏,陈蓓蓓,刘金凤. 热碱处理破解污泥效果研究[J]. 环境科技,2013,26(2):38-42
    [25] SEVILLA M, FUERTES A B．Chemical and structural properties of carbonaceous products obtained by hydrothermal carbonization of saccharides[J].Chemistry,2009,15(16):4195-4203 10.1002/chem.200802097
    [26] MURSITO A T,HIRAJIMA T,SASAKI K.Upgrading and dewatering of raw tropical peat by hydrothermal treatment[J].Fuel,2010,89(3):635-641 10.1016/j.fuel.2009.07.004
    [27] WANG L,LI A.Hydrothermal treatment coupled with mechanical expression at increased temperature for excess sludge dewatering:The dewatering performance and the characteristics of products[J].Water Research,2015,68:291-303 10.1016/j.watres.2014.10.016
    [28] ZHAO P,SHEN Y,GE S,et al.Energy recycling from sewage sludge by producing solid biofuel with hydrothermal carbonization[J].Energy Conversion and Management,2014,78(2):815-821 10.1016/j.enconman.2013.11.026
    [29] SCHUHMACHER J P,HUNTJENS F J,VAN K D W.Chemical structure and properties of coal XXVI studies on artificial coalification[J].Fuel,1960,39:223-234
    [30] XUE T,HUANG X.Releasing characteristics of phosphorus and other substances during thermal treatment of excess sludge [J].Journal of Environmental Sciences,2007,19(10):1153-1158 10.1016/S1001-0742(07)60188-0
  • 加载中
WeChat 点击查看大图
计量
  • 文章访问数:  1713
  • HTML全文浏览数:  1440
  • PDF下载数:  398
  • 施引文献:  0
出版历程
  • 刊出日期:  2018-05-19

涂料废渣水热减量及其产物特性

  • 1. 东华大学环境科学与工程学院，上海201620
  • 2. 江苏同盐环保科技有限公司，盐城224000
基金项目:

国家自然科学基金资助项目（51508084）

江苏省自然科学基金资助项目（BK20150434）

摘要: 采用水热技术处理涂料废渣，考察了水热温度、反应时间、含水率和投碱量对涂料废渣减量及其产物特性的影响，并用SEM、元素分析对涂料废渣进行表征。实验结果表明：随着水热温度的升高及时间的延长，涂料废渣减量效果及水热液中COD、TN浓度不断增加，固体产物的热值也随之增加，而含水率对涂料废渣减量的影响不大；随着碱投加量的增加，涂料废渣减量效果和水热液中COD、TN浓度逐渐提高，固体产物的热值呈不规则变化。水热温度220 ℃、水热时间4 h、含水率77.5%、投碱量0.17 g（NaOH，投加量以每克干物质（DS）计）为涂料废渣减量的最佳反应条件。在最优条件下，总减量率和干重减量率分别为79.1%和52.1%，含水率为47.2%。水热固体产物热值较高，可以作燃料为其他工艺提供热能。

English Abstract

参考文献 (30)

目录

/

返回文章
返回

Copyright © 2019 中国科学院生态环境研究中心